Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual11 · AT - Automatic Transmission
11 · Transmission

TROUBLE-SHOOTING AND DIAGNOSES - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › TROUBLE-SHOOTING AND DIAGNOSES - Nissan 200SX S12 Workshop Manual
AT - Automatic TransmissionTROUBLE-SHOOTING AND DIAGNOSES - Nissan 200SX S12 Workshop Manual

TROUBLE-SHOOTING AND DIAGNOSES

TROUBLE-SHOOTING AND DIAGNOSES

Preliminary Checks. Road Testing

(Prior to Road Testing)

Before starting road tests, install vacuum gauge,

FLUID LEAKAGE

To detect a fluid leek: : 1}, Raise vehicle. 2). Clean area suspected of leaking, 3} Start engine, apply foot brake, place selector lever in drive, and wait a few minutes, 4) Stop engine, 5) Check for fresh leakage. e— fo}>

, FLUID CONDITION

|} Examine the A.T.F. and note its color, texture, SATEG6 + and odor. 1) Dark of Black Fluid: © Perform road tests, using “Symptom” chart, as With a burned odor follows: Worn friction materlal, 2) Milky Pink Fluld: Water Contarpinstion

“P” RANGE

i — Road water entering through filler

1. Place selector lever in “P*" range and start the b tube or breather, ‘engine. Stop the engine

+) Varnished Fluid, light to dark brown and

and repeat the proce- dure in ali other ranges inciuding neutrat, { tacky: Oxidation i

2. Stop vehicle on # slight upgrade and place — Over or Underfitling. selector lever in “P” range. Release parking ~ Overheating. brake to make sure vehicle remains locked, RANGE

1. Move selector lever from “P" to “R”, and note shift quality.

2. Drive the vehicle in reverse long enough to detect slippage or other abnormalities.

“N" RANGE

- Manually shift the selector lever from “A” and “D" to "N” and note quality.

2. Release parking brake with selector lever in "N” range. Lightly depress accelerator pedal to make sure vehicle does not move, (When vehicle is new or soon after clutches have been replaced, vehicle may move slightly. This is not aproblem.}

“D" RANGE

1. Move salector lever from “N” to “D" range, and note shift quality.

AT-57

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.