ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
Manual Linkage Adjustment —__ Move the shift lever from the “Prange to “Range Loosen the attaching bolts. 1". You should be able to feel the detents in each With an aligning pin, [2.0 mm (0.079 in) dia.) range. move the switch until the pin falls into the hole If the detents cannot be felt or the pointer indicat- in the rotor. ing the range is improperly aligned, the linkage needs adjustment.
1. Place shift lever in “N’’ range. '
2. Loosen locknuts,
‘SsAaToos
j, Tighten the attaching bolts equally.
Recheck for continuity. If necessary, replace the switch.
3. Move range selector lever to the “N’’ range,
satzay 4, Tighten lock nuts when floor selector lever is in “'N’ range pushing selector lever toward the “P" range side,
5. Move selector lever from “P”” range to “"1"" range. Make sure that selector lever can move smoothly.
AT-11
Parts & tools for this job For Nissan 200SX
- PARTTransmission filter kitSearch: Nissan 200SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.