REPAIR FOR COMPONENT PARTS - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 200SX S12 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Direct Clutch & Front Clutch (Cont‘d)
DISASSEMBLY ‘ (iris blocked here ¢ Compress clutch springs and remove’ snap ring from spring retainer using Tool.
‘SaT58a 4 Lubricate clutch drum hub and seals, and install inner seal and piston seal as illustrated, saress Be careful not to stretch seals during instal- For easy removal of piston from drum, mount lation. clutch on drum support, Use an air gun with a tapered rubber up to carefully apply air pres- sure to loosen piston from drum. -
satoa
5. Assemble piston, being careful not to allow seal to kink or become damaged during installation. After installing, turn piston by hand to ensure that there is no binding.
INSPECTION AND ASSEMBLY
1, Check clutch drive plate facing for wear or damage. Standard thickness:
1.50 - 1.65 mm (0.0591 - 0.0650 in) Wear limit:
1.4. mm (0.055 in)
2. Check for wear on snapring, weak or broken coil springs, and warped spring retainer. 3, Check the operation of check ball in piston using compressed air. saTos2 AT-35
Parts & tools for this job For Nissan 200SX
- PARTTransmission filter kitSearch: Nissan 200SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.