ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
——~— Vacuum Diaphragm Rod
Downshift Solenoid —___ Adjustment
1. Remove downshift soienoid and O-ring.
1. Remove diaphragm from transmission case. Catch oil dropping out of the hole,
2, With a depth gauge, measure depth “L”. Be
sure vacuum throttle valve is pushed into valve body as far as possible,
3. Check “L” depth with chart below and select
proper length rod,
Vacuurn diaphragm Note vested valve body — Trangnission cogs wall “U" Ovet a5 on sATsIS \
um rod
Vecnum tortn wah
var pody ue pate OO
2. Check to verify that downshift solenoid is operating properly. If necessary, replace it with satom anew one. ‘Vacuum dlapheage rod selection
| Measured depth"L"] re tin) | od Gh] mma tinh | part number |
|---|---|---|
| re tin) | mma tinh | |
| Under 26.85 (1.0068) | 20.0 (1.142) | aa eISS |
| 25.68 - 28.05 (1.0098 - 1.0256) | | 208 1.161) | SIR AOIO |
| 26.18 - 26,55 (1.0208 - 1.0453) | | 200 (1.181) | sipezxor00) |
| 20,08 - 27.08 (1.0492 - 1.0860) | | 308 (1.201) | Siesennotog |
| Over 27.18 (1.0689) | a0 (1.220) | Sea ED Ow! |
Beery eater
AT-12
Parts & tools for this job For Nissan 200SX
- PARTTransmission filter kitSearch: Nissan 200SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.