REMOVAL AND INSTALLATION - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › REMOVAL AND INSTALLATION - Nissan 200SX S12 Workshop Manual
REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
Removal Installation © Remove bolts securing torque converter to Drive plate runout drive plate. Maximum allowable runout:
0.5 mm (0.020 in)
saTH a, Remove those bolts turning crank shaft.
b. Before removing torque converter, inscribe If this runout is out of allowance, replace drive plate and ring gear. matching marks on two parts so that they may be replaced in their original positions during When connecting torque converter to trans . assembly. mission, measure distance A’ to be certain that they are correctly assembled. © Plug up openings such as oil charging pipe, etc. Distance “A”:
CAUTION: ‘More than 36 mm (1.38 in) Take care not to strike any adjacent parts when dismounting transmission.
Install converter to drive plate. Align matching marks painted across both party during disassembly. Before installing torque converter securi bolts, apply locking sealer to threads of bol After converter is installed, rotate cranksha several turns and check to be sure that tran mission rotates freely without binding.
AT-14
Parts & tools for this job For Nissan 200SX
- PARTTransmission filter kitSearch: Nissan 200SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.