Suspension (page 4 of 7)
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Repairs
SuspensionSuspension · page 4 of 7
| A | Self – locking nut | I | Socket wrench |
| B | Damper mounting collar | J | Dust cover sleeve |
| C | Damper spring | K | Spring mounting rubber |
| D | Bump stop plate | L | Damper mounting rubber |
| E | Bump stop | M | Damper mounting base |
| F | Spring seat rubber | N | Damper mounting seal |
| G | Damper unit | O | Damper mounting rubber |
| H | 10 mm Nut | P | Damper mounting washer |
WARNING: The front and rear dampers contain nitrogen gas and oil under pressure. The pressure must be relieved before disposal to prevent explosion and possible injury when scrapping.
CAUTION: Replace self-locking nuts after removal.
- Check damper mounting seal, mounting rubber and spring seat for weakness.
- Check damper spring for weakened compression or damage
- Check bump stop for weakness, cracks or damage.
- Check damper unit for rust, oil leaks and smooth operation through a full stroke in both directions.
Parts & tools for this job For Rover 600
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Rover 600 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.