Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Engine - KV605 Engine - diesel06 Engine - T Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - KV612 Cooling system - diesel13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Manual gearbox - T75017 Automatic gearbox - JF403E18 Drive shafts19 Steering20 Brakes21 Restraint systems22 Body23 Air conditioning24 Wipers & washers25 Electrical26 Instruments
Rover 800 Workshop Manual (1996-1999)02 · General information
02 · General

Identification number locations

Make
Rover
Model
800 Workshop Manual
Year
1996–1999
Section
Vehicle identification number › Identification number locations
General informationIdentification number locations

IDENTIFICATION NUMBER LOCATIONS

Engine number

2.0 ’T’ Series Engine: Stamped above No.4 cylinder block core plug.

2.5 KV6 engine: Stamped on rear face of LH cylinder bank adjacent to gearbox.

Diesel Engine: Stamped on a plate attached to the front face of cylinder block below injection pump.

Manual gearbox number

2.0 & 2.5 petrol models: Stamped on a label attached to the front face of the clutch housing.

2.5 diesel models: Stamped on a label attached to the front face of the clutch housing.

Automatic Gearbox number

2.0 petrol models: Stamped on a plate attached to the bottom face of the gearbox.

2.5 petrol models: Stamped on the top face of the gearbox.

Body number

The body number is stamped on a plate fixed to the floor to the LH side of the spare wheel compartment.

Parts & tools for this job For 1996 Rover 800

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.