EON Function (Enhanced Other Network)

EON Function (Enhanced Other Network)

In certain countries circuits which cover several transmitters broadcasting traffic information are grouped together.

In these cases listening to the RDS TP station programme will be temporarily interrupted to receive traffic information each time it is transmitted by one of the transmitters in the same circuit.

In order to exclude this function (EON), briefly press the "TP" switch (10) (the LED under the switch will go out).

Scanning programmed stations (SCAN Function)

With this function it is possible to cyclically tune in, for 10 seconds at a time, to all the stations which can be received which have been previously programmed on this band.

During scanning, when a station is tuned into, the LED under the switch where it is programmed comes on and the number of the switch appears on the display.

Stations where the signal is too weak cannot be heard.

In order to select the SCAN function, proceed as described below:

• select the band desired;
• press the "SCAN" switch (16) (the LED under the switch comes on).

It is possible to change the direction of the search several times by pressing the "MODE +" (9) or "MODE -" (7) switches.

In order to interrupt the scanning, press the "SCAN" switch (16) again : the LED under the switch will go out and the station present at that moment will be heard.

Stereo transmitters

When the station is transmitting the programme in stereo, the symbol shown by the arrow in the diagram below will appear on the display.

If the signal arriving is weak, the reproduction will be automatically switched from Stereo to Mono.