Alternator - diesel (page 2 of 2)

Refit

1. Clean mating faces of alternator and vacuum Alternator - V8 pump.
2. Fit vacuum pump to alternator and tighten

$% 86.10.02 bolts to 8 Nm (6 lbf.ft).

3. Position alternator to engine and connect

Remove

multiplug.

4. Connect vacuum hose and oil drain hose to vacuum pump and secure clips.
5. With assistance align alternator to mounting bracket and fit but do not tighten bolt.
6. Fit bolt securing support stay to alternator and tighten to 25 Nm (18 lbf.ft) .
7. Tighten bolt securing alternator to mounting bracket to 45 Nm (33 lbf.ft).
8. Using new 'O' ring, connect oil supply pipe to cylinder head and tighten to 10 Nm (7 lbf.ft).
9. Connect lead to alternator and tighten nut to 6 Nm (4.4 lbf.ft).
10. Fit auxiliary drive belt tensioner and tighten bolt to 50 Nm (37 lbf.ft).
11. Fit auxiliary drive belt. CHARGING AND STARTING, REPAIRS, Belt - auxiliary drive.
1. Remove auxiliary drive belt. CHARGING AND STARTING, REPAIRS, Belt - auxiliary drive.

2. Remove 2 bolts securing alternator to mounting bracket.
3. Release alternator from mounting bracket

4. Remove nuts securing alternator cables, and release cables.