Range Rover P38
LAND ROVER V8
53
REPAIR
NOTE: Long bolts: 1, 3, 5.
15. Fit bolts and tighten in the sequence shown to
20 Nm (15 lbf.ft) then 90
°
, then a further 90
°
.
16. Clean push rods.
17. Lubricate ends of push rods with clean engine
oil.
18. Fit push rods in their removed order.
19. Clean base of rocker pillars and mating faces on
cylinder head.
20. Clean contact surface on rockers, valves and
push rods.
21. Lubricate contact surfaces and rocker shaft with
clean engine oil.
22. Fit rocker shaft assembly and engage push rods.
23. Tighten rocker shaft securing bolts progressively
to
38 Nm (28 lbf.ft).
24. Fit and tighten engine harness bolt to
20 Nm (15
lbf.ft).
25. Refit rocker cover.
26. Ensure dipstick tube and mating face on cylinder
block is clean.
27. Apply Loctite 638 to end of dipstick tube and fit
tube and dipstick to cylinder block.
28. Fit exhaust manifold.
See MANIFOLD AND
EXHAUST SYSTEM, Repair.
29. Fit inlet manifold gasket.
See MANIFOLD AND
EXHAUST SYSTEM, Repair.
CYLINDER HEAD GASKET (RH) - from 99MY
Service repair no - 12.29.03
Remove
1. Remove inlet manifold gasket.
See MANIFOLD
AND EXHAUST SYSTEM, Repair.
2. Remove RH exhaust manifold gasket.
See
MANIFOLD AND EXHAUST SYSTEM, Repair.
NOTE: RHD models: Exhaust manifold will
remain captive in engine bay but clear of
cylinder head.
3. Remove bolt securing auxiliary drive belt
tensioner and remove tensioner.