Range Rover P38
LAND ROVER V8
41
REPAIR
7. Disconnect Lucar from oil pressure switch.
8. Position container below switch to catch oil
spillage.
9. Remove oil pressure switch and discard ’O’ ring.
Refit
10. Clean oil pressure switch threads.
11. Fit new ’O’ ring to switch.
12. Fit oil pressure switch and tighten to
15 Nm (11
lbf.ft).
13. Connect Lucar.
14. Ensure oil cooler return pipe union is clean and
fit new ’O’ ring to pipe.
15. Align oil cooler return pipe to alternator support
bracket and fit but do not tighten bolt at this
stage.
16. Tighten oil cooler return pipe union to
15 Nm (11
lbf.ft).
17. Tighten bolt securing oil cooler return pipe to
alternator support bracket.
18. Fit oil filter.
See this section.
19. Connect battery earth lead.
20. Fit battery cover and secure with fixings.
21. Top up engine oil.
STRAINER - OIL PICK-UP
Service repair no - 12.60.20
Remove
1. Remove sump gasket.
See this section.
2. Remove 2 bolts and 1 nut securing oil pick-up
strainer.
3. Remove oil pick-up strainer.
4. Collect spacer from stud.
5. Remove and discard ’O’ring.
Refit
6. Clean oil pick-up strainer and ’O’ ring recess.
7. Lubricate and fit new ’O’ ring.
8. Locate spacer on stud.
9. Position oil pick-up strainer, fit and tighten, bolts
to
10 Nm (7 lbf.ft) and, nut to 22 Nm (17 lbf.ft).
10. Fit new sump gasket.
See this section.