Brake pedal play inspection
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Conventional Brake System › Brake pedal play inspection
BrakesBrake pedal play inspection
See also: live page (the same text is also in the 2008 2.0L manual)
Fig. 5: Adjusting Brake Pedal Height
Courtesy of MAZDA MOTORS CORP.
BRAKE PEDAL PLAY INSPECTION
- Depress the pedal several times to release the vacuum in the power brake unit.
- Gently depress the pedal by hand, and measure the pedal play.
- If not within the specification, inspect the wear of the clevis pin and replace it if there is any malfunction.
Brake pedal play
2-5 mm {0.08-0.19 in}
NOTE: If there is no malfunction in the clevis pin, there is a possibility that the power brake unit has some malfunction. Verify that there are no malfunctions, and replace it if necessary.
PEDAL-TO-FLOOR CLEARANCE INSPECTION
- Start the engine and depress the pedal with a pedal force of 147 N {15.0 kgf, 33.0 lbf} .
- Measure the distance between the pedal pad center and the insulator, and verify that it is as specified.
- If the pedal-to-floor clearance is less than the specification, check for air in the brake system.
Brake pedal-to-floor clearance (Brake pedal when depressed at 147 N {15.0 kgf, 33.0 lbf}
106.9 mm {4.209 in} or more
Parts & tools for this job For 2006 Mazda MX-5
- PARTBrake padsSearch: Mazda MX-5 2006 brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.