Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Lateral Runout Inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Conventional Brake System › Lateral Runout Inspection
BrakesLateral Runout Inspection
BRAKES – Conventional Brake System – figure
Fig. 39: Rear Brake Inspection & Repair Flow Procedure
Courtesy of MAZDA MOTORS CORP.

Lateral Runout Inspection

  1. To secure the disc plate and the hub, insert the washer (thickness 10 mm {0.39 in} , inner diameter more than 12 mm {0.47 in} ) between each hub bolt and the hub nut, then tighten all the hub nuts.

NOTE: The component parts of the SST (49 B017 001 or 49 G019 003) can be used as a suitable washer.

  1. After tightening all the hub nuts to the same torque, put the dial gauge on the friction surface of disc plate 10 mm {0.39 in} from the disc plate edge.
  2. Rotate the disc plate one time and measure the runout.

Rear disc plate runout limit

0.05 mm {0.002 in}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.