Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Disc Plate Thickness Inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Conventional Brake System › Disc Plate Thickness Inspection
BrakesDisc Plate Thickness Inspection
BRAKES – Conventional Brake System – figure
Fig. 41: Inspecting Disc Plate-To-Pad Friction Surface
Courtesy of MAZDA MOTORS CORP.

Disc Plate Thickness Inspection

CAUTION: Excessive runout may result if the disc plate is removed from the vehicle then machined. Machine the disc plate while installed on the vehicle.

  1. Measure the thickness of the disc plate.
    • If the thickness is not within the specification, replace the disc plate.

Minimum rear disc plate thickness

8 mm {0.31 in}

Minimum rear disc plate thickness after machining using a brake lathe on-vehicle

8.8 mm {0.35 in}

Disc Pad Thickness Inspection

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.