Power brake unit inspection
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Conventional Brake System › Power brake unit inspection
BrakesPower brake unit inspection
Fig. 17: Identifying Brake Fluid Level Sensor Connector
Courtesy of MAZDA MOTORS CORP.
POWER BRAKE UNIT INSPECTION
NOTE: The following inspection methods are simple inspection methods to judge the function of the power brake unit.
If there is any malfunction in the power brake unit, replace the power brake unit as a single unit.
WITHOUT USING SST
Operation Inspection
- With the engine stopped, depress the pedal several times.
- With the pedal depressed, start the engine.
- If the pedal moves down slightly immediately after starting the engine, the unit is normal.
Vacuum Function Inspection
- Start the engine.
- After driving the vehicle for 1-2 min , stop the engine.
- Depress the pedal with normal force.
- If the first pedal stroke is long and becomes shorter with subsequent strokes, the unit is normal.
- If a problem is found, inspect for damage to or improper installation of the check valve and vacuum hose. After repairing, inspect again.
Vacuum Loss Function Inspection
- Start the engine.
- Depress the pedal with normal force.
- With the pedal depressed, stop the engine.
- Maintain the pedal depressed for approx. 30 s .
- If the pedal height does not change during this time, the unit is normal.
USING SST
Pre-inspection Preparation
- Install the SST (49 N043 001) in the orientation shown in Fig. 18 , (with DSC)
NOTE: Install the SST (49 N043 001) to the master cylinder using a commercially available flare nut wrench.
Parts & tools for this job For 2006 Mazda MX-5
- PARTBrake padsSearch: Mazda MX-5 2006 brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.