Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS)
BrakesDiagnostic procedure · page 2 of 2
4INSPECT ABS HU/CM
POWER SUPPLY FOR
OPEN CIRCUIT
• Start the engine.
• Measure the voltage between ABS HU/CM terminal J and ground.
• Is the voltage approx.
10 V?
YesGo to the next step.
NoRepair or replace the wiring harness for open circuit between the ABS HU/CM and ground, then go to Step 6.
5INSPECT ABS HU/CM
GROUND FOR POOR
GROUND OR OPEN
CIRCUIT
• Turn the ignition switch off.
• Measure the resistance between ground and
ABS HU/CM terminal
D.
• Is the resistance within
0-1 ohm?
YesGo to the next step.
NoIf there is no continuity.
• Repair or replace the wiring harness for open circuit between the ABS HU/CM and ground, then go to the next step.
If the resistance is not within 0-1 ohm:
• Repair or replace harness for poor ground, then go to the next step.
6VERIFY
TROUBLESHOOTING
COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory.
• (See CLEARING
DTCS
PROCEDURES .)
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Is the same DTC present?
YesReplace the ABS HU/CM, then go to the next step. (See ABS HU/CM
REMOVAL/INSTALLATION .)
NoGo to the next step.

7

VERIFY AFTER REPAIR

Yes

Go to the applicable DTC inspection.

PROCEDURE

(See DTC Table .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.