Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS)
BrakesDiagnostic procedure · page 2 of 2
  • Drive the vehicle.
  • Verify that the wheel speed-signals are transmitted from each ABS wheel-speed sensor.
  • Are the wheel-speed signals transmitted?

2

INSPECT FOR OPEN

Yes

Replace the ABS wheel-speed sensor,

CIRCUIT IN WIRING

then go to the next step. (See FRONT ABS WHEEL-SPEED

HARNESS BETWEEN ABS HU/CM AND ABS

SENSOR

WHEEL-SPEED SENSOR

REMOVAL/INSTALLATION .) (See REAR ABS WHEEL-SPEED SENSOR

  • Turn the ignition REMOVAL/INSTALLATION .) switch off.
  • Disconnect the ABS HU/CM connector and ABS wheel-speed sensor.
  • Inspect for continuity in the wiring harness between the following ABS wheel-speed sensor connectors on the vehicle wiring harness-side and ABS HU/CM connectors.
  • RF ABS wheel-speed sensor (+): M-A
  • RF ABS wheel-speed sensor (-): O-B
  • LF ABS wheel-speed sensor (+): F-A
  • LF ABS wheel-speed sensor (-): E-B
  • RR ABS wheel-speed sensor (+): I-A
  • RR ABS wheel-

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.