Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)08 · Steering
08 · Steering & suspension

Fluid pressure inspection (page 3 of 4)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Power Steering
SteeringFluid pressure inspection · page 3 of 4
STEERING – Power Steering – figure
Fig. 4: Connecting SSTs
Courtesy of MAZDA MOTORS CORP.
  1. Bleed the air from the system. (See AIR BLEEDING .)
  2. Open the gauge valve fully.
  3. Start the engine and turn the steering wheel fully left and right to raise the fluid temperature to 50-60°C {122-140°F} .
  4. Close the gauge valve completely.
  5. Increase the engine speed to 1,000-1,500 rpm and measure the fluid pressure generated by the oil pump.
    • If the pressure is not within the specification, repair or replace the oil pump component.

CAUTION: If the valve is left closed for more than 5 seconds, the fluid temperature will rise excessively and adversely affect the oil pump.

Oil pump fluid pressure

7.55-8.05 MPa {77.0-82.0 kgf/cm2 , 1095-1167 psi}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.