Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)08 · Steering
08 · Steering & suspension

Fluid pressure inspection (page 4 of 4)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Power Steering
SteeringFluid pressure inspection · page 4 of 4
STEERING – Power Steering – figure
Fig. 5: Inspecting Fluid Pressure (Valve Closed)
Courtesy of MAZDA MOTORS CORP.
  1. Open the gauge valve fully and increase the engine speed to 1,000-1,500 rpm .
  2. Turn the steering wheel fully to the left and right, then measure the fluid pressure generated at the gear housing.
    • If the pressure is not within the specification, repair or replace the steering gear component.

CAUTION: If the steering wheel is kept in the fully turned position for more than 5 seconds, the fluid temperature will rise excessively and adversely affect the oil pump.

Gear housing fluid pressure

7.55-8.05 MPa {77.0-82.0 kgf/cm2 ,1095-1167 psi}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.