Motorized throttle manual mode operation check

Turn the ignition key to the OFF position

Using a finger, place the throttle valve in the fully open position and check that it moves evenly.

Remove your finger from throttle valve (1) and check that it returns to its preset position (with a valve opening of 7° (2) in relation to the completely closed position, moving evenly thanks to the return spring and the opening spring).

Using a finger, place the throttle valve in the fully closed position and check that it moves evenly, then remove your finger and check that it returns to its normal preset position

Move on to Step 2

Replace the motorized throttle

Op. 1056B14

Check on motorized throttle operation

Turn the key to MAR, and within 5 seconds

gradually press the accelerator pedal and check that the throttle valve moves evenly until it is completely open

Release the accelerator pedal and check that the throttle valve returns to its preset position

Throttle actuator resistance check

Turn the ignition key to the OFF position

Disconnect the motorized throttle connector

Using an Examiner in ohmmeter mode, measure the resistance between terminals 3 and 5 of the throttle actuator and check that the resistance is about 2 ohm ± 10% at 20°C

See E5030 PETROL ENGINES ELECTRONIC MANAGEMENT

Replace the motorized throttle

Op. 1056B14

Motorized throttle manual mode operation check

Turn the ignition key to the OFF position

Using a finger, place the throttle valve in the fully open position and check that it moves evenly.

Remove your finger from throttle valve (1) and check that it returns to its preset position (with a valve opening of 7° (2) in relation to the completely closed position, moving evenly thanks to the return spring and the opening spring).

Using a finger, place the throttle valve in the fully closed position and check that it moves evenly, then remove your finger and check that it returns to its normal preset position

Move on to Step 2

Replace the motorized throttle

Op. 1056B14

Check on motorized throttle operation

Turn the key to the MAR position

Gradually press the accelerator pedal and check that the throttle valve moves evenly until it is completely open

Release the accelerator pedal and check that the throttle valve returns to its preset position

Throttle actuator resistance check

Turn the ignition key to the OFF position

Disconnect the motorized throttle connector

Using an Examiner in ohmmeter mode, measure the resistance between terminals 1 and 4 of the throttle actuator and check that the resistance is about 3 ohm ± 10% at 20°C

See E5030 PETROL ENGINES ELECTRONIC MANAGEMENT

Replace the motorized throttle

Op. 1056B14