Turn the ignition key ON.

With the engine off and all users off, the Target Turbocharging Pressure must be within a range of 0.9 to 1.2 bar.

Under the same conditions, the Measured Turbocharging Pressure must be in the range of 0.9 to 1.2 bars and in any case must be approximately equal to external pressure.

With the engine idling and accelerator pedal not operated, the Target Turbocharging Pressure must be within a range of 0.9 to 1.2 bar.

Under the same conditions, the Measured Turbocharging Pressure must be within a range of 0.9 to 1.2 bars.

Continue with the test.

See Test 1064BA TURBOCHARGING PRESSURE CHECK

With the accelerator pedal slightly pressed and engine speed equal to 3000 rpm, the Target Turbocharging Pressure must be within a range of 1 to 2.3 bar.

Under the same conditions, the Measured Turbocharging Pressure must be within a range of 1 to 1.3 bar.

The test can be considered over

Turn the ignition key OFF.

Disconnect the wiring loom connector from the air temperature and pressure sensor.

Turn the ignition key ON.

Measure the voltage between regulator (wiring side) Pins 3 and 1

See K044 AIR TEMPERATURE/PRESSURE SENSOR

Ensure that it is in a range of between 4.8 and 5.2 V.

- Restore the wiring between the engine management control unit and the sensor

- Replace the engine management control unit

Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - R.R