VACUUM RESEVOIR - R.R

Operation 1060G70 · DIESEL INJECTION PRESSURE PUMP ELECTRONIC CONTROL

1.9 JTD 8v

Removing

Op. 1016A10 SOUND-PROOFING COVER - R.R

1. Disconnect the vacuum pipes from the vacuum tank.

2. Undo nuts (2a) and remove vacuum tank (2b).

Refitting

- Place the vacuum tank back in its housing and secure it using the nuts.

- Connect the vacuum pipes to the vacuum tank.

- Connect the oil vapour recovery pipe to the engine oil vapour separator and tighten the band.

Op. 1016A10 SOUND-PROOFING COVER - R.R

1.9 JTD 16v

Removing

Op. 1016A10 SOUND-PROOFING COVER - R.R

1. Undo the nut (1a) and move the heater plugs control unit (1b) to one side as necessary.

1. Undo nuts securing the vacuum reservoir to the mounting.

- Disconnect the electrical connection for the throttle casing solenoid valve.

2. Disconnect the vacuum pipes (2a) and remove the vacuum reservoior (2b).

Mark the position of the pipes before removing them.

1. If necessary, undo the bolts and remove the throttle body solenoid valve (1a) from the vacuum reservoir (1b).

Refitting

- Fit the throttle body solenoid valve on the vacuum reservior and tighten the bolts.

- Connect the vacuum pipes to the vacuum reservoir.

- Connect the electrical connection for the throttle casing solenoid valve.

- Fit the vacuum reservoir in position and tighten the nuts.

- Place the heater plugs control unit in position and tighten the nut.

Op. 1016A10 SOUND-PROOFING COVER - R.R