Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Clock not working

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Instrument panel › Clock not working
Fault diagnosisClock not working

CLOCK NOT WORKING

With the ignition on, the display either does not show the time or it is not correct.

TEST RESULTS
1INSTRUMENT PANEL FUNCTIONS CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check:

- That the display shows the correct time

- That it is possible to adjust the time

- That the clock moves forward

Move on to Step 2

1. The time displayed is not correct

2. It is not possible to adjust the time

3. The clock stays still

4. The display/time is not clear

1. Adjust the time

2. Move on to Step 4

3. Replace the instrument panel

Op. 5560B10 CONTROL PANEL - R+R

4. Move on to Step 2

2CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the Examiner diagnostic equipment to the diagnostic socket.

Check that there are no faults in the instrument panel

Move on to Step 3Presence of errorsContinue following the instructions for the diagnostic equipment
3CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION
Keeping the Examiner equipment connected to the diagnostic socket, check the operation of the display in active diagnosis.End of diagnosisDisplay defective

Replace the instrument panel

Op. 5560B10 CONTROL PANEL - R+R

4ELECTRICAL CIRCUIT CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check:

- Connections between centre control panel in dashboard and instrument panel

- Control panel earth

See E4010 INSTRUMENT PANEL

Move on to Step 5Connections defective, earth or power supply defectiveRestore the correct connections, if necessary, replace the wiring.
5MODE BUTTON CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check that the MODE button is working properly see wiring diagram

See E4010 INSTRUMENT PANEL

End of diagnosisMODE button defective

Replace the left control panel

Op. 7040A56 SWITCH UNIT IN DASHBOARD - R.R.

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.