Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Airbag failure warning light on

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Instrument panel › Airbag failure warning light on
Fault diagnosisAirbag failure warning light on

AIRBAG FAILURE WARNING LIGHT ON

When starting, the Air Bag warning light comes on and stays on for longer than 4 seconds (the warning light should go off after the initial control unit test)

The warning light will stay on if an impact of a certain severity activates the system. The control unit must be replaced because its memory cannot be cleared

The Air Bag warning light is the smart type with a control circuit inside the panel that ensures the warning light is properly connected to the control unit.

TEST RESULTS
1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the diagnostic test equipment (Examiner or other instruments) to the tester input.

Check:

- for faults in the Air Bag control unit;

- the plausibility of all the parameters

Move on to Step 2

1. No communication with the control unit

2. Error detected in the control unit

1. Restore:

a) connection between the Air Bag control unit and diagnostic connector;

b) Air Bag control unit power supply

See E7030 AIRBAG

2. Continue following the instructions on the diagnostic equipment

2INCORRECT OPERATION CHECK ON THE RELEVANT WARNING LIGHTALL OKPROBLEMS ENCOUNTEREDACTION
Use the tester to carry out active diagnosis on the relevant warning light while in air bag control unit modeMove on to Step 3The warning light does not flash

Replace the instrument panel

Op. 5560B10 CONTROL PANEL - R+R

3CHECK THE WIRINGALL OKPROBLEMS ENCOUNTEREDACTION

Check the connection between the Air Bag control unit and the CAN

See E7030 AIRBAG

End of diagnosis

1. Connections not correct

2. Air Bag control unit defective

1. Restore the correct connections.

2. Replace the Air Bag control unit

Op. 5580C14 AIR BAG ECU - R+R

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.