Electric power assisted steering fault display
- Make
- Fiat
- Model
- Bravo Factory Service Manual
- Year
- 2007–2014
- Section
- Instrument panel › Electric power assisted steering fault display
‹ Prev The turbo pressure gauge led does not workNext › Water in diesel filter warning light off (initial test not carried out)
Fault diagnosisElectric power assisted steering fault display
ELECTRIC POWER ASSISTED STEERING FAULT DISPLAY
The electric steering node comunicates fault messages to the instrument panel node via the C-CAN and through the gateway at the B-CAN
| 1 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|---|---|---|---|
| Connect the diagnosis equipment and check there are no faults at the Electric Steering Node | Move on to Step 2 | Presence of faults | Continue as described by the diagnostic equipment | |
| No faults present | Move on to Step 2 | |||
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
- Connect the diganostic equipment to the electric steering control unit and check: - In active diagnosis that the warning light is working properly | Move on to Step 3 | The warning light does not flash | Replace the instrument panel | |
| 3 | CORRECT OPERATION CHECK | All OK | Problems encountered | Operation |
| Check that the body computer is working properly | End of diagnosis | Body Computer defective | Replace Body Computer |
‹ Prev The turbo pressure gauge led does not workNext › Water in diesel filter warning light off (initial test not carried out)
Parts & tools for this job For 2007 Fiat Bravo
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Fiat power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.