Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Croma Factory Service Manual (2005-2010)22 · Fault diagnosis
22 · Diagnostics

Gearbox noise - in neutral

Make
Fiat
Model
Croma Factory Service Manual
Year
2005–2010
Section
Noise / vibrations › Gearbox noise - in neutral
Fault diagnosisGearbox noise - in neutral

GEARBOX NOISE - IN NEUTRAL

With the vehicle stationary, the gearbox in neutral and the engine running, there is a high frequency, low intensity noise coming from the area of the gearbox.

Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation

Visually inspect whether the problem is accompanied by an oil leak from the gearbox/differential.

Press the clutch pedal and check whether the noise increases.

Check the gearbox/differential oil level

Op. 0010T41 MANUAL GEARBOX OIL CHECK LEVEL AND TOP UP IF NECESSARY

Move on to Step 1Oil leak detected from the gearbox

Identify and eliminate the cause of the leak.

Restore the oil level.

The noise disappears or decreases considerably with the clutch pedal pressed: the noise comes from inside the gearbox

Proceed as instructed in the

See table S015 NOISE WHILST DRIVING

Oil level too low.

Restore the correct level

Op. 0010T41 MANUAL GEARBOX OIL CHECK LEVEL AND TOP UP IF NECESSARY

and carry out a road test. If the fault persists, move on to Step 1

1SPLINED HUB CHECKAll OKProblems encounteredOperation
Check for excess grease on the clutch plate hub bushes and the gearbox main shaftMove on to Step 2Gearbox main shaft hub faulty

Replace the gearbox main shaft

Op. 2110B MANUAL GEARBOX WITH DIFFERENTIAL GEARS AND SYNCHRONISERS

Clutch plate hub bushes faulty.

Restore the correct lubrication for the bushes. If necessary, replace the clutch plate

Op. 1810A20 CLUTCH - R + R

2CLUTCH PLATE CHECKAll OKProblems encounteredOperation

Check:

- Clutch plate wear;

- Fouling (oil or grease) of the clutch plate;

- That there is no distortion of the clutch plate;

- That there is no damage to the pressure plate diaphragm spring.

End of diagnosisClutch plate or pressure plate faulty

Replace the clutch plate

Op. 1810A20 CLUTCH - R + R

Presence of oil or grease.Also replace the gearbox input oil seal

Parts & tools for this job For 2005 Fiat Croma

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.