TD5 Defender
CHASSIS AND BODY
25
REPAIR
Refit
12. Position panel assembly, fit bolts and nut and
tighten to 10 Nm (7lbf.ft).
13. Connect multiplug to motor.
14. Secure harness clips and sleeve.
15. Connect interior handle link to latch and secure
with clip.
16. Connect multiplug to solenoid, locate solenoid to
mounting panel and tighten screws.
17. Fit and secure link.
18. Remove wedges, lower glass and locate to
regulator. Fit bolts and tighten to 6 Nm (4 lbf.ft).
19. Raise and lower glass to check operation.
20. Fit plastic sheet. See this Section.
21. Adjust door lock solenoid. See ELECTRICAL,
Adjustment.
PANEL - MOUNTING - REAR DOOR - FROM 02MY
Service repair no - 76.11.29
Remove
1. Remove plastic sheet. See this Section.
2. Lower glass and remove 2 bolts securing door
glass to regulator.
3. Release glass from regulator, raise and wedge
in raised position.