Discovery II
ENGINE - V8
12-2-30 REPAIRS
Refit
1. Clean mating faces of engine and gearbox,
dowel and dowel holes.
2. Lubricate splines and bearing surface on first
motion shaft with grease.
3. With assistance position engine in engine bay,
align to gearbox and locate on dowels.
4. Position support brackets, fit bell housing bolts
and tighten to 50 Nm (37 lbf.ft).
5. Position engine mountings, fit nuts and tighten
to 85 Nm (63 lbf.ft).
6. Lower lifting equipment and remove from
engine.
7. Models with automatic gearbox: Align torque
converter to drive plate, fit bolts and tighten to
50 Nm (37 lbf.ft). Fit access plug.
8. Fit exhaust front pipe.
SYSTEMS - V8, REPAIRS, Front pipe.
9. Position oil cooling pipe saddle clamps and
tighten bolts.
10. Position engine harness into foot well.
11. Connect 5 multiplugs to ECM.
12. Fit toe board and secure with trim fixings.
13. Connect engine harness earth to body and
secure with nut.
14. Connect engine harness to main harness
multiplug.
15. Connect multiplug to EVAP purge valve.
16. Connect engine harness multiplugs to fuse
box.
17. Connect starter lead to fuse box and secure
with nut.
18. Connect engine harness positive lead to
battery and tighten nut.
19. Fit fuse box cover.
20. Position engine earth lead and secure with
bolt.
21. Position coolant rail and secure with bolt.
22. Connect harness clips to coolant rail.
23. Connect hose to coolant rail and coolant pump
and secure with clips.
24. Connect PAS pump high and low pressure
pipes and secure with clips.
25. Position oil cooling pipe saddle clamp to PAS
pump housing and secure with bolt.
26. Clean A/C compressor and housing mating
faces, dowels and dowel holes.
27. Position A/C compressor, fit bolts and tighten
to 22 Nm (16 lbf.ft).
28. Connect multiplug to A/C compressor.
29. Clean ACE pump and housing mating faces,
dowels and dowel holes.
30. Position ACE pump, fit bolts and tighten to 22
Nm (16 lbf.ft).
31. Clean all pulley 'V's, fit auxiliary drive belt,
using a 15mm spanner, release belt tensioner
secure belt and re-tension drive belt .
32. Ensure auxiliary drive belt is correctly located
on all pulleys.
33. Fit radiator.
34. Fit top hose and secure with clips.
35. Connect fuel pipe to fuel rail.
36. Position ignition coils and connect ht leads.
37. Fit upper inlet manifold.
SYSTEMS - V8, REPAIRS, Gasket - inlet
manifold - upper - Without Secondary Air
Injection.
38. Fit new oil filter and refill engine with oil.
ENGINE - V8, REPAIRS, Filter - oil.
39. Top up gearbox oil.