L322 Range Rover Service Procedures
BRAKES
REPAIRS
70-25
5. Release sensor lead from damper, remove
Allen screw and release ABS sensor from hub.
Refit
1. Clean ABS sensor, smear sensor with an anti-
seize grease and fit sensor to hub.
LUBRICANTS AND SEALANTS,
Lubrication.
2. Fit Allen screw securing ABS sensor and
tighten to 8 Nm (6 lbf.ft).
3. Secure sensor lead to damper, brake hose
bracket, clip and body bracket then connect
and secure multiplug. Close cover on multiplug
housing.
4. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
5. Remove stand and lower vehicle.
6. To ensure correct operation, the ABS system
MUST be tested using TestBook/T4.
ABS sensor - rear wheel
$% 70.65.31
Remove
1. Raise front of vehicle, one side.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Remove 5 screws securing wheel arch liner
and release liner for access to multiplug
housing.
4. Open cover on multiplug housing, release and
disconnect sensor multiplug then release
sensor lead from suspension turret and
suspension arm.
5. Release sensor lead from damper, remove
Allen screw and release ABS sensor from hub.
M70 1131