L322 Range Rover Service Procedures
BRAKES
REPAIRS
70-19
Sensor - pad wear - front
$% 70.40.04
Remove
1. Raise front of vehicle, one side.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove LH front road wheel.
3. Open cover on multiplug housing, release and
disconnect pad wear sensor multiplug.
4. Release sensor lead from body bracket, clip,
brake hose bracket and bleed screw dust cap.
5. Disconnect pad wear sensor from brake pad.
6. Remove sensor.
Refit
1. Fit sensor to pad.
2. Secure sensor lead to bleed screw dust cap,
brake hose bracket, clip and body bracket then
connect and secure multiplug. Close cover on
multiplug housing.
3. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
4. Remove stand(s) and lower vehicle.
M70 1118