L322 Range Rover Service Procedures
ENGINE - V8
REPAIRS
12-2-9
14. Position LRT-12-227 through timing tool
access hole and secure flywheel in TDC
position.
15. Fit LH VCC unit.
Engine - V8, REPAIRS, Variable
camshaft unit - variable camshaft control
(VCC) - LH.
16. Fit coolant pump to coolant manifold pipes.
Pipe(s) - coolant pump to coolant manifold.
17. Fit LH exhaust manifold.
- V8, REPAIRS, Gasket(s) - exhaust manifold
- LH.
18. Fit new oil filter and fill engine with oil.
Engine oil and filter - V8 engine.
19. Fill cooling system.
ADJUSTMENTS, Coolant - drain, flush &
refill.
20. Connect battery earth lead.
Gasket - cylinder head - RH
$% 12.29.03
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Position vehicle on lift.
2. Disconnect battery earth lead.
3. Drain cooling system.
ADJUSTMENTS, Coolant - drain, flush &
refill.
4. Drain engine oil and remove oil filter.
Engine oil and filter - V8 engine.
5. Remove RH exhaust manifold.
- V8, REPAIRS, Gasket(s) - exhaust manifold
- RH.
6. Remove coolant pump to coolant manifold
Pipe(s) - coolant pump to coolant manifold.
7. Remove RH VCC unit.
Engine - V8, REPAIRS, Variable
camshaft unit - variable camshaft control
(VCC) - RH.
8. Fit LRT-12-226 to VCC solenoid and remove
solenoid.
CAUTION: Do not allow oil to come into
contact with the drive belts while removing
the solenoid.