Finisher - rear seat squab

SEATS

REPAIRS 76-5-11

Refit

1. Position seat cover to cushion and secure with 

hog rings.

2.  Fit 14 staples securing cover under cushion.
3. Position cushion to frame and secure rear of 

cover.

4. Fit stud securing rear cover.
5. Feed heated seat harness through seat frame 

and secure multiplug to retaining clip.

6. Position seatbelt lower buckle to frame and 

secure with Torx bolt tighten to 31 Nm (23 
lbf.ft).

7. Fit seat cover sides and front beading.
8. Fit Torx bolt securing squab frame to seat 

frame, tighten to 45 Nm (33 lbf.ft).

9. Connect multiplug to squab harness.

10. Fit seat fold mechanism.

 + 

 SEATS, REPAIRS, Hinge - rear seat 

- side.

11. Fit seat base finisher.

 + 

 SEATS, REPAIRS, Finisher - seat 

base rear.

Finisher - rear seat squab 

$% 78.55.03

Remove

1. Fold rear seat forward.
2. Release 3 clips securing latch finisher, remove 

finisher.

3. Remove 2 screws securing lower squab 

finisher.

4. Release 3 retaining clips securing finisher and 

remove finisher.