L322 Range Rover Service Procedures
SEATS
76-5-24 REPAIRS
Refit
1. Position and fit drive cable to motor assembly.
2. Carefully fit motor assembly to mounting
bosses.
3. Fit 'E' clips securing motor assembly.
4. Position squab frame to seat frame, fit Torx
bolts tighten to 25 Nm (18 lbf.ft).
5. Position harness and secure retaining clips.
6. Connect multiplugs to headrest and squab
motor.
7. Connect multiplug to heated seat circuit.
8. Connect lumbar harness multiplugs to lumbar
pump and valve.
9. Position backboard to seat assembly, fit studs
securing lower of backboard.
10. Position and fit both sides of squab cover to
backboard.
11. Position lower squab cover to backboard and
staple.
12. Fit backboard tension straps to under seat
retaining clips.
13. Fit armrest to boss and secure with Allen bolt,
tighten to 25 Nm (18 lbf.ft).
14. Fit seat assembly.
Motor - fore & aft - front seat
$% 78.70.25
Remove
1. Remove seat assembly.
2. Disconnect multiplug from fore and aft motor.
3. Remove 2 Torx bolts from fore and aft motor
and remove motor.
Refit
1. Position fore and aft motor and secure with
Torx bolts, tighten to 10 Nm (7 lbf.ft).
2. Connect multiplug to fore and aft motor.
3. Fit seat assembly.