Range Rover P38
12
ENGINE
NEW RANGE ROVER
48
REPAIR
9. Release 2 heated oxygen sensor multiplugs
from sump brackets.
10. Remove 3 nuts and 14 bolts securing sump to
cylinder block.
11. Remove sump.
Refit
12. Clean sealant from mating faces of sump and
cylinder block.
13. Apply a bead of Hylosil type 101 or 106 sealant
to joint face of sump as shown.
Bead width - areas A, B, C and D = 12 mm (0.5
in)
Bead width - remaining areas = 5 mm (0.20 in)
Bead length - areas A and B = 32 mm (1.23 in)
Bead length - remaining areas = 19 mm (0.75 in)
CAUTION: Do not spread sealant bead.
Sump must be fitted immediately after
applying sealant bead.
14. Position sump to cylinder block taking care not to
disturb sealant bead.
15. Fit nuts and bolts securing sump to cylinder
block and tighten in the sequence shown to
23
Nm (17 lbf.ft) .
16. Fit sump plug and tighten to
45 Nm (33 lbf.ft).
17. Engage oxygen sensor multiplugs to sump
brackets.
18. Fit engine acoustic cover (if applicable).
See
CHASSIS AND BODY, Repair.
19. Fit gearbox acoustic cover (if applicable).
See
CHASSIS AND BODY, Repair.
20. Raise ramp and remove support.
21. Lower vehicle.
22. Fill engine oil.
See LUBRICANTS, FLUIDS
AND CAPACITIES, Information.
23. Fit dip stick.