Head/valve train (page 2 of 5)

5. Remove the cylinder head cover.
6. Remove the side engine mount bracket B (standard for some types).
7. Remove the upper cover.
8. Remove the side engine mount.
9. Remove the dipstick and the pipe.
10. Remove the pulley bolt and the crankshaft pulley. Remove the two rear bolts from the centre beam to allow the engine to drop down and give clearance to remove the lower cover.
11. Remove the rubber seal around the adjusting nut. Do not loosen the adjusting nut.
12. Remove the lower cover.

Note:

• Replace any rubber seals which have been damaged or have deteriorated.
• Replace the dipstick/pipe O-ring.
• Remove all traces of oil from the internal and external crankshaft pulleys.