Head/valve train (page 4 of 5)
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Cylinder head/valve train: repairs
EngineHead/valve train · page 4 of 5
- Remove the timing belt.
Note: Mark the direction of rotation before removing belt.
- Install the timing belt in the reverse order of removal.
- Adjust the valve clearances.
Note: Before installing the timing belt, position the crankshaft at TDC compression for No 1 piston.
- Adjust the timing belt tension.
- Tighten the 6 x 1.0mm bolt to lock the timing belt adjuster arm.
Parts & tools for this job For Rover 600
- PARTEngine gasket setSearch: Rover 600 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.