Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat 500 Factory Service Manual (2007-2024)22 · Fault diagnosis
22 · Diagnostics

Rear creaking

Make
Fiat
Model
500 Factory Service Manual
Year
2007–2024
Section
Noise / vibrations › Rear creaking
Fault diagnosisRear creaking

REAR CREAKING

1.2 8v, 1.3 Multijet, 1.4 16v

With the vehicle moving, particularly over rough ground or during acceleration or braking, noise can be heard from the rear of the passenger compartment

Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Check that the noise is actually coming from the rear of the passenger compartment.Move on to Step 1The noise is coming from one of the rear doors

Proceed as instructed

See table S063 REAR DOORS CREAKING

1REAR SEAT FASTENINGS CHECKAll OKProblems encounteredOperation

Check the correct fastening:

  • of the cushion to the body;
  • of the backrest to the luggage compartment bulkhead;
  • of the rear seat belt mountings to the body.
Move on to Step 2

1. Seat fastenings not correct

2. Rear seat belt fastening not correct

1. Renew the correct fastening.

Op. 7005A10 FRONT SIDE DOOR - ADJUST STRIKER AND ADAPT SEAL IF NECESSARY

2. Renew the correct fastening.

Op. 7065B10 REAR SEAT BELT (ONE), LEFT OR RIGHT - R.R.

2REAR PARCEL SHELF CHECKAll OKProblems encounteredOperation

Remove the rear parcel shelf and check:

  • For the presence of noise prevention rubber mountings on the rear parcel shelf rear hooks;
  • That the elements on the rear parcel shelf (e.g. speakers) are correctly fastened;
  • That the boot wiring coupling is correctly insulated.
Move on to Step 3

1. Rubber mountings or insulation missing.

2. Fastenings faulty

1. Renew the rubbing mountings and insulating material

2. Restore the correct fastening of the elements to the rear parcel shelf.

3REAR PILLAR COVER CHECKAll OKProblems encounteredOperation

Remove the pillar covers and check:

  • for the presence of the felt between the pillar cover and the pillar;
  • for the presence of the felt between the pillar cover and the rear parcel shelf.
Move on to Step 4Felt missing.Renew felt.
4SPLIT SEAT CHECKAll OKProblems encounteredOperation
Remove the seat and check that the welding for the backrest perimeter joining back is correct.End of diagnosisWelding faulty.

Replace the seat assembly

Op. 7050A11 SPLIT REAR SEAT, ONE LEFT OR RIGHT - R.R.

Parts & tools for this job For 2007 Fiat 500

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.