22 · Diagnostics

Milometer/trip meter flashing

Make: Fiat
Model: Croma Factory Service Manual
Year: 2005–2010
Section: Instrument panel › Milometer/trip meter flashing

‹ Prev Lights check warning light off (initial test not carried out)Next › Battery charging warning light not working

Fault diagnosisMilometer/trip meter flashing

MILOMETER/TRIP METER FLASHING

At the end of the lights check the panel milometer/trip meter starts to flash

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment and check in the "Control Units Test" ambient, "Other Systems" Assembly, "Proxi Alignment Procedure" Systems, that the "Instrument Panel Node" alignment has taken place	Move on to Step 8	1. Impossible to carry out Proxi alignment	1. Move on to Step 2
		Move on to Step 8	2. Alignment not carried out	2. Carry out Proxi alignment
2	INSTRUMENT PANEL CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the panel installed is correct for the vehicle trim level (a panel for a petrol version cannot be fitted on a diesel version)	Move on to Step 3	Panel does not correspond with the vehicle trim level	Replace instrument panel Op. 5560B10 CONTROL PANEL - R+R
3	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment and check, in the Instrument Panel Node ambient, that there are no errors and that the parameters are present	Move on to Step 8	1. Connection with NQS impossible	1. Move on to Step 4
		Move on to Step 8	2. Presence of errors	2. Move on to Step 7
4	ELECTRICAL POWER SUPPLY CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the electrical power supply for the "Instrument Panel Node" is correct See E4010 INSTRUMENT PANEL	Move on to Step 5	Positive and/or earth electrical power supply faulty	Renew and/or replace the defective component (in the case of a fuse, find out what caused it to blow).
5	ELECTRICAL CONNECTIONS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the wiring/electrical connections for the Instrument Panel Node, in particular that every pin is correctly connected and fitted in place	Move on to Step 6	Wiring and/or electrical connections not working	Restore the wiring and/or damaged electrical connections
6	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner, check the possibility of connecting with the Instrument Panel Node	Move on to Step 7	Impossible to connect with the control unit	Replace instrument panel Op. 5560B10 CONTROL PANEL - R+R
7	CHECK ERRORS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check for the presence of one or more of the following errors using the Examiner in the Instrument Panel Node ambient: CAN line EEPROM	Move on to Step 8	1. "No additional information" and/or "BUS off" detected	1. Continue as described by the diagnostic equipment
		Move on to Step 8	2. EEPROM faulty	2. Replace instrument panel Op. 5560B10 CONTROL PANEL - R+R
8	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check, using the Examiner in active diagnosis that the autotest function is correctly activated	Move on to Step 9	The function in question is not controlled by the active diagnosis	Replace instrument panel Op. 5560B10 CONTROL PANEL - R+R
9	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present.	End of diagnosis

‹ Prev Lights check warning light off (initial test not carried out)Next › Battery charging warning light not working

Parts & tools for this job For 2005 Fiat Croma

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.