ALARM DESCRIPTION

2.0 16V JTD, 2.2 16V JTD · MY 2005

The vehicle is equipped with an electronic alarm with perimeter (exterior) and volumetric (interior) protection.

The alarm is switched on/off using the remote control incorporated in the key.

The remote control incorporated in the key has 4 buttons:

- one for activating the central locking (locking) command, switching on the alarm and the location function;

- one for activating the release of the central locking and switching off the alarm.

- one for opening/closing the right sliding side door;

- one for opening/closing the left sliding side door.

See E3095 SLIDING SIDE DOORS

A dedicated control unit monitors the following:

- the state of the doors and lids, via switches in the catches (perimeter control)

- the presence of a moving object inside the passenger compartment, by means of volume-sensing sensor (volumetric control)

- the condition of the system supply leads;

- operation of the ignition switch.

The control unit is equipped with an autodiagnostic function which detects and memorizes faults and problems in the actual control and the system components; in addition, it checks the condition of the connecting cables and memorizes the number of activations and times the alarm has been operated.

The control unit operating logic can be modified in order to satisfy the legal requirements which govern the use of alarm systems in the various markets.

All the outside components are connected by means of a dedicated serial line.

The alarm siren is located at the front, on the left of the engine compartment.

The deterrent LED is located on the right side of the dashboard: with the alarm on the LED flashes at 0.8 [Hz] to indicate that the vehicle is locked (dissuasion function).

The door lock system switches are used to monitor the doors and boot.

A special separate switch detects bonnet closure.

The volumetric sensors check that there are no intrustions in the vehicle. Located in the front courtesy light, they consist of a transmitter and a receiver: the wave transmitted by one transmitter must reach the receiver of the other sensor and viceversa: otherwise an alarm signal is sent to the control unit.

The volume-sensing function may be deactivated by pressing a special button that is accessible only with the driver''s door open: a led on the instrument panel comes on with a fixed light. In this case, when the anti-theft device is switched on, there is perimeter (external) protection only.