TD5 Defender
12
ENGINE
22
REPAIR
MOUNTING - GEARBOX - REAR - RH
Service repair no - 12.45.09
Remove
1. Remove LH rear gearbox mounting. See this
Section.
2. Remove 4 bolts securing mounting bracket to
transfer gearbox.
3. Remove 2 nuts, remove mounting and mounting
bracket.
Refit
4. Clean mounting and mating faces.
5. Position mounting and mounting bracket and
tighten nuts to 48 Nm (35 lbf.ft) and bolts to 85
Nm (63 lbf.ft).
6. Fit LH rear gearbox mounting. See this
Section.
FLYWHEEL
Service repair no - 12.53.07
Remove
1. Remove clutch assembly. See CLUTCH,
Repair.
2. Remove and discard 8 bolts securing flywheel to
crankshaft and remove flywheel.
NOTE: Dowel located.
Refit
3. Clean flywheel and crankshaft mating face.
4. Position flywheel to crankshaft.
5. Fit new flywheel retaining bolts and tighten by
diagonal selection to:
Stage 1 - 40 Nm (30 lbf.ft)
Stage 2 - Further 90
°
CAUTION: Do not carry out stages 1 and 2
in one operation.
6. Fit clutch assembly. See CLUTCH, Repair.