TD5 Defender
12
ENGINE
4
REPAIR
Refit
9. Position new crankshaft pulley to vice.
10. Remove 3 bolts and remove damper from
crankshaft pulley.
11. Using a lint free cloth, thoroughly clean oil seal
recess and the running surface on crankshaft
pulley.
12. Fit crankshaft pulley.
13. Fit LRT-51-003 to crankshaft pulley and secure
with 2 bolts.
14. Fit new crankshaft pulley bolt and tighten to 460
Nm (340 lbf.ft).
NOTE: It is recommended that a torque
multiplier is used to tighten crankshaft
pulley bolt.
15. Remove 2 bolts and remove LRT-51-003 from
crankshaft pulley.
16. Fit damper to crankshaft pulley, fit bolts and
tighten to 80 Nm (60 lbf.ft) .
17. Fit auxiliary drive belt.
18. Fit radiator. See COOLING SYSTEM, Repair.
19. Fit underbelly panel. See CHASSIS AND
BODY, Repair.
OIL SEAL - CRANKSHAFT - REAR
Service repair no - 12.21.20
Remove
1. Remove flywheel. See this Section.
2. Remove sump gasket. See this Section.
3. Remove 5 bolts securing oil seal housing to
cylinder block.
4. Remove seal housing.
Refit
5. Clean seal housing mating face on cylinder
block.
6. Position seal protector, LRT-12-061 over
crankshaft boss. Fit new seal and housing
assembly and remove tool LRT-12-061.
CAUTION: Oil seal must be fitted dry.