TD5 Defender Engine Gasket - Engine to Sump
12
ENGINE
26
REPAIR
15. Position oil pump drive sprocket and chain on to
oil pump ensuring that the ’D’ shape on the drive
sprocket is located on flat on the oil pump drive
shaft.
16. Clean oil pump drive sprocket retaining bolt and
apply Loctite 242 to bolt threads.
17. Fit oil pump drive sprocket retaining bolt and
tighten to 25 Nm (18 lbf.ft).
18. Fit new sump gasket. See this Section.
GASKET - ENGINE TO SUMP
Service repair no - 12.60.38
Remove
1. Remove battery cover.
2. Disconnect battery negative lead.
3. Remove exhaust front pipe. See MANIFOLD
AND EXHAUST SYSTEM, Repair.
4. Drain engine oil.
5. Loosen 4 bolts securing sump to gearbox bell
housing.
6. Remove 2 bolts securing centrifuge drain pipe to
sump and discard gasket.
7. Using sequence shown and noting their fitted
position, remove 20 bolts securing sump.
8. Remove sump, remove and discard gasket.
CAUTION: Do not lever between sump and
cylinder block.