Gearbox - V8 (page 3 of 4)

28. Remove bolt securing breather pipe 'P' clip and

24. Remove clevis pin and 'C' washer securing low ratio selector cable to lever and release cable from lever housing. 29. If fitted:

30. If fitted:
31. Position container to catch oil spillage
25. Remove 2 cable ties securing cable to fuel pipes.

32. Remove 3 bolts securing oil cooling pipe
33. Using a second jack support the weight of the
26. Disconnect 2 Lucars from oil temperature sensor and disconnect reverse lamp switch multiplug.
27. Remove banjo bolts securing breather pipes and discard sealing washers.

release breather pipes.

Disconnect 2 Lucars from differential lock switch, release and disconnect transfer box neutral sensor multiplug. Release harness from 2 retaining clips.

housing to gearbox, release housing and discard 'O' rings.

engine.