Range Rover P38
ABS
13
REPAIR
PARKING BRAKE CABLE
Service repair no - 70.35.25
Remove
1. Raise vehicle on four post lift.
2. Remove master switch pack from centre
console.
See ELECTRICAL, Repair.
3. Remove clevis pin securing brake cable to lever.
4. Raise lift.
5. From under vehicle pull cable through grommet
in floor. Refit grommet to floor.
6. Remove brake shoes.
See this section.
7. Release cable from backplate.
Refit
8. Fit cable to backplate.
9. Fit brake shoes and drum.
See this section.
10. Feed brake cable through grommet into vehicle.
11. From inside vehicle, align cable to handbrake
lever. Secure with clevis pin and clip.
12. Fit master switch pack.
See ELECTRICAL,
Repair.
13. Adjust parking brake.
See Adjustment.