Range Rover P38
ABS
15
REPAIR
CALIPER GUIDE PIN BOOTS
Service repair no - 70.55.32
Remove
1. Remove brake pads.
See this section.
2. Remove remaining bolts securing caliper body to
carrier.
3. Release caliper body from carrier. Tie aside. Do
not strain hydraulic hose.
4. Remove 2 guide pins. Collect boot from each
guide pin.
Check
5. Clean guide pins, bores and boots.
6. Inspect guide pins and bores. Renew guide pins
if scored or excessively corroded.
7. Inspect boots for splits. Replace as necessary.
Refit
NOTE: If new guide pin boots are to be
fitted, lubricate with grease supplied. If
existing boots are to be re-used, lubricate
with Kluber Syntheso ’GLK 1’ grease.
8. Fit guide pins and boots. Ensure boots locate
correctly.
9. Untie caliper body, position to carrier. Fit upper
guide pin bolt. Tighten to
30 Nm. (22 lbf.ft)
10. Fit brake pads.
See this section.
PARKING BRAKE DRUM AND SHOES
Service repair no - 70.45.17 - Brake Drum
Service repair no - 70.45.18 - Brake Shoes
WARNING: Do not use an air line to
remove dust from brake assembly. Dust
from brake linings can be a serious health
risk if inhaled.
Remove
1. Raise vehicle on four post lift.
2. Release hand brake. Raise lift.
3. Remove 4 bolts securing rear propshaft guard.
Remove guard.