Range Rover P38
ABS
23
REPAIR
STOP LIGHT SWITCH - UP TO 99MY
Service repair no - 70.35.42
Remove
1. Remove driver side fascia closing panel.
See
CHASSIS AND BODY, Repair.
2. Remove 3 scrivet fasteners securing lower
closing panel. Release panel for access to
blower motor ducting.
3. Release ducting from blower motor housing and
heater. Remove blower motor ducting.
4. Release multiplug from stop light switch.
5. Remove stop light switch from pedal bracket.
Refit
6. Engage switch fully into pedal bracket location.
7. Connect multiplug.
NOTE: The stop light switch is factory set
and requires no adjustment in service.
8. Position blower ducting, fit to heater and blower
motor housing locations.
9. Position lower closing panel and secure with
scrivet fasteners.
10. Fit driver side fascia closing panel.
See
CHASSIS AND BODY, Repair.