Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

CAUTION: @ When installing sliding parts such as bearings and pistons,

be sure to apply engine oil on the sliding surfaces.

@

Place removed parts such as bearings and bearing caps in

their proper order and direction. @

When tightening connecting rod bolts and main bearing

cap bolts, apply engine oil to thread portion of bolts and

seating surface of nuts.

Disassembly

PISTON AND CRANKSHAFT

ee Ce og Place engine on a work stand. C Le is KV10108101 ‘wc KV10106500 Remove timing belt. oy Ao J emhTM Oh Drain coolant and remove water pump. Cet oN Drain oil. 1 \ > Remove oil pan and oil pump. Pap Remove cylinder head.

Remove pistons. TM @

When disassembling piston and connecting rod, remove

Snap ring first, then heat piston to 60 to 70°C (140 to 158°F)

or use piston pin press stand at room temperature.

SEM8778

8. Remove bearing cap and crankshaft. @ Before removing bearing cap, measure crankshaft end play. @ Bolts should be loosened in two or three steps.

SEmM360C Inspection

PISTON RING SIDE CLEARANCE

we | Side clearance: Top ring Feeler

0.040 - 0.073 mm (0.0016 - 0.0029 in) gauge O.K. 2nd ring

0.030 - 0.063 mm (0.0012 - 0.0025 in) Max. limit of side clearance:

0.1 mm (0.004 in) } Feeler gauge

if out of specification, replace piston and/or piston ring as-

/ — Ring SEMO24A4A sembly. — EM-34

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.