CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Inspection (Cont'd)
VALVE GUIDE CLEARANCE
1, Measure valve deflection in a parallel direction with rocker arm. (Valve and valve guide mostly wear in this direction.) Valve deflection limit (Dial gauge reading):
0.2 mm (0.008 in)
ate aprox 26 mm 10.8}
2. If it exceeds the limit, check valve to valve guide clearance. Q “xz a, Measure valve stem diameter and valve guide inner diameter.
b. Check that clearance is within specification Valve to valve guide clearance limit: Inside micro ala
0.1 mm (0.004 in)
c. If it exceeds the limit, replace valve or valve guide
Valve Se%5278
Valve guide
VALVE GUIDE REPLACEMENT
1. To remove valve guide, heat cylinder head to 150 to 160°C (302 to 320°F).
2. Drive out valve guide with a press [under a 20 KN (2 t, 22 US ton, 2.0 Imp ton) pressure] or hammer and suitable tool
3. Ream cylinder head valve guide hole. Valve guide hole diameter (for service parts} Intake and Exhaust
10.175 - 10.196 mm (0.4006 - 0.4014 in)
EM-21
Parts & tools for this job For Nissan 180SX
- PARTEngine gasket setSearch: Nissan 180SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.