Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

OIL SEAL REPLACEMENT - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › OIL SEAL REPLACEMENT - Nissan 180SX S13 Workshop Manual
EM engine mechanicalOIL SEAL REPLACEMENT - Nissan 180SX S13 Workshop Manual

OIL SEAL REPLACEMENT

OIL SEAL REPLACEMENT

OIL SEAL INSTALLING DIRECTION

Engine Engine € . outside inside Dust seal lip Oil seal iP

SEM?715A

CAMSHAFT OIL SEAL

Suitable tool

1. Set No. 1 piston at T.D.C. on its compression stroke. Remove crank angle sensor, front cover, timing belt, cam- shaft sprockets and rear dust cover. 3 Remove camshaft oil seal. Be careful not to scratch camshaft.

4. Apply engine oil to camshaft oil seal lip and install it in place.

FRONT OIL SEAL

1. Set No. 1 piston at T.D.C. on its compression stroke.

2. Remove timing belt and crankshaft sprocket.

3. Remove front oil seal. 4 Apply engine oil to oil seal lip and install it in place using suitable tool.

REAR OIL SEAL

Remove transmission and flywheel. Remove rear ail seal from the retainer. Apply engine oil to oil seal lip and install it in place using suitable tool.

SEM560B

VALVE OIL SEAL

7

Set No. 1 piston at T.D.C. on its compression stroke.

Remove throttle chamber and rocker covers. wry Remove camshafts and valve lifters. 9 AO. OL Remove spark plug. SOO © CF © Ap

Install air hose adapter into spark plug hole and apply air

pressure to hold valves in place. [Apply pressure of 490 kPa © i (4.9 bar, 5 kg/cm’, 71 psi)] / S| - f Air SEM562B EM-14

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.