CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Inspection (Cont'd)
CAMSHAFT CAM HEIGHT
1. Measure camshaft cam height Standard cam height: Intake
39.785 - 39.815 mm (1.5663 - 1.5675 in) Exhaust
40.485 - 40.515 mm (1.5939 - 1.5951 in) Cam wear limit:
0.2 mm (0.008 in)
2. If wear is beyond the limit, replace camshaft SEMBa94,
CAMSHAFT JOURNAL CLEARANCE,
1. Install camshaft bracket and tighten bolts to the specified torque.
2. Measure inner diameter of camshaft bearing Standard inner diameter:
28.000 - 28.025 mm (1.1024 - 1.1033 in)
3. Measure outer diameter of camshaft journal, Standard outer diameter:
27.935 - 27.955 mm (1.0998 - 1.1006 in)
4. If clearance exceeds the limit, replace camshaft and/or cylinder head. Camshaft journal clearance limit:
0.15 mm (0.0059 in)
CAMSHAFT END PLAY
1. Install camshaft in cylinder head. 2, Measure camshaft end play. Camshaft end play: Standard
0.07 - 0.15 mm (0.0028 - 0.0059 in) Limit 0.2 mm (0.008 in)
CAMSHAFT SPROCKET RUNOUT
1. Install sprocket on camshaft.
2. Measure camshaft sprocket runout Runout (Total indicator reading): Limit 0.1 mm (0.004 in)
3. If it exceeds the limit, replace camshaft sprocket.
Semsase EM-20 a
Parts & tools for this job For Nissan 180SX
- PARTEngine gasket setSearch: Nissan 180SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.